Dinan

39 position connector with 20 standard terminals and 14 high current PMU terminals Learn More

One black 39 position connector and gray 24 position connector with 63 terminals Learn More

One set of Gray and Black 24 position connectors with 48 terminals for ECUMaster EMU Classic Learn More

One 35 position AMPSEAL connector and 35 terminals for ECUMaster ADU Learn More

Includes Bosch 4.9 Sensor, 6 pin Amp connector and terminals Learn More

Includes Bosch 4.9 Sensor, 5 foot harness, 6 pin Amp connector and terminals Learn More

Includes Bosch 4.2 Sensor, connector and terminals Learn More

Includes Bosch 4.2 Sensor, 5 foot harness, 6 pin Amp connector and terminals Learn More

The CAN H-Bridge device contains two independent H-Bridges with over-current and short circuit protection, capable of 10A continuous current and 30A peak current. H-Bridges can be controlled via device inputs or CAN bus messages. Voltage range: 6V - 28V (12V and 24V automotive installations) Output current: 10A continuous, 30A peak 4 analogue (0-5V) / digital (35Hz - 200Hz PWM) inputs Output PWM: 12bit 3.9kHz The CAN H-Bridge device can be used to supply protected low side (GND) or high side (VBat) supply independently to each of 4 outputs for bidirectional DC motor control. Low side outputs can be PWM modulated on per-bridge basis. Learn More