We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
Dinan
Shop By
Nissan S13 SR20 (J4/J5) PNP (64 pin)2 In StockManufacturer: DinanEMU Classic, EMU, EMU CAN Learn More
ECUMaster EMU Classic2 In StockManufacturer: DinanStandalone ECU, built-in 4 bar MAP sensor, drives Bosch 4.2 directly, two EGT inputs, 6 sequential channels for fuel and ignition, on-board igniter Learn More
Wideband O2 Kit, Bosch 4.9, connector and terminals2 In StockManufacturer: DinanIncludes Bosch 4.9 Sensor, 6 pin Amp connector and terminals Learn More
Wideband O2 Kit, Bosch 4.2, connector and terminals2 In StockManufacturer: DinanIncludes Bosch 4.2 Sensor, connector and terminals Learn More
Dual H-Bridge1 In StockManufacturer: DinanThe CAN H-Bridge device contains two independent H-Bridges with over-current and short circuit protection, capable of 10A continuous current and 30A peak current. H-Bridges can be controlled via device inputs or CAN bus messages. Voltage range: 6V - 28V (12V and 24V automotive installations) Output current: 10A continuous, 30A peak 4 analogue (0-5V) / digital (35Hz - 200Hz PWM) inputs Output PWM: 12bit 3.9kHz The CAN H-Bridge device can be used to supply protected low side (GND) or high side (VBat) supply independently to each of 4 outputs for bidirectional DC motor control. Low side outputs can be PWM modulated on per-bridge basis. Learn More
Drive By Wire Module for EMU1 In StockManufacturer: DinanEnables use of DBW Throttle Body with the EMU Learn More